Related Product
16,449৳
Your shopping cart is empty!
The DHT11 Humidity & Temperature Sensor Module is a basic, low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air and outputs a digital signal on the data pin (no analog input pins needed). Its very simple to use, and libraries and sample codes are available for Arduino and Raspberry Pi. CityTech BD
This DHT11 Humidity & Temperature Sensor Module makes is easy to connect to an Arduino or microcontroller as it includes the pull-up resistor required to use the sensor. Only three connections are required to be made to use the sensor – Vcc, Gnd, and Output. We have also included the cables required to connect the DHT11 to a microcontroller. CityTech BD
CityTech BD CityTech BD CityTech BD CityTech BD CityTech BD CityTech BD CityTech BD CityTech BD CityTech BD
General Specification | |
Model | DHT11 |
Input Supply voltage (VDC) | 3.3 ~ 5 |
Supply Current (mA) | measurement 0.3mA standby 60μA |
Temperature range (°C) | 0 ~ 50 |
Temperature measurement error | ±2°C |
Humidity measurement range | 20% ~ 95%RH |
Humidity measurement error | ±5%RH |
Resolution | 16 Bit |
Output form | Digital output |
Length (mm) | 28 |
Width (mm) | 13.5 |
Height (mm) | 7 |
Weight (gm) | 448 5 |
Shipment Weight | 0.03 kg |
Shipment Dimensions | 5 × 4 × 3 cm |
1 x DHT11 Temperature And Humidity Sensor Module.
3 x Female to Female connecting cable
CityTech BD CityTech BD CityTech BD